No Sew Mosaic Table Runner

How we did it:
Materials List
- contact paper
- tissue paper
- scissors
- wrapping paper - or wax paper
-
For this no-sew table runner, you will need a roll of contact paper, tissue paper, and a roll of wrapping paper (about the same width as your contact paper). Instead of wrapping paper you could also use wax paper, or any other paper you have on hand.
-
Roll out and cut a piece of contact paper the length of your table. Take the paper off of the back of the contact paper and set it on the table sticky side up. I put a few pieces of tape on each end to keep it from rolling back up.
-
Cut or rip the tissue paper into shapes and place them on the sticky contact paper. If you use tissue paper that has a design, remember to stick it with the design facing down so it will show on the finished product.
-
When you are finished putting the tissue paper on, roll the wrapping paper (or wax paper) over your design (the top of the wrapping paper face down).
-
When we flipped it over, ours looked like this.